Відео

The bolt torque specification for this type of Mitsubishi valve cover is 4 Nm (newton-meters) or 35.4 lb-in (inch-pounds).

Thank you for the video! That was an easy job.

Folks. When you replace you alternator make sure to check the connector plug. This model is a four pin. You can end up with an alternator that has a three pin if you’re not careful. The fourth pin in the newer model tells the ecu to raise the rpm’s if the alternator is under a heavy load. The three pin units do not have that wire to send that signal to the ecu.

God I feel for the mechanics who have to work on this modern crap.

Someone's got the trip button right in the dash by the rpm gauge

This seems like a pretty easy job, but that transmission tube gives me a little pause. Simply removing and putting it back is all there is to it?

Set my 2014 Dodge Grand caravan is turn on the whole whining as well so start with new transmission filter and fluid ?

18:34 do not EVER pull that hose off like that you sloppshop SHOULD Know Better what you just did

This is a 5 star 🌟excelent video.thank you so much .im a Diy gal 2002 toyota camry le .2.4 4cylinder

Great video

My 2007 Cobalt driver's side headlight is very dim. I put a new bulb in and it's still very dim. Could that be a fuse issue?

Great Video thanks

❤

Hi how long did it take u to complete that job

Why would a 2005 highlander start blowing hot air out of nowhere? Could it be the blow motor or ac control?

Where was door brace on reinstall?

focus ur goddamn camera. liberal

Dude turn your engine off

How did you ck the Freon Level ??

A relay is a Relay you just purchased a bad one .

Why not just test the Fuckin Relay ?? Swap the Horn and clutch relay for test .

Saved me $400. Thank you sir.

Thank you!

Hi great video. When you did this do you recall if the key fob opened the back glass?

Thanks, great video and really helpful!

Too much noise couldn't watch!!!

Is anybody have a clue can you please help me

I have a 2006 Buick rendezvous I change the belts was driving home and on Sunday just shut off on me and doesn't even want to start or turn over what can it be

NAPA let you carry their name ? Holy cow!!

terrible sound.

No, this does not help at all. It does not show the vacuum line routing to and from the vacuum ball or where it needs to connect on the other side of the firewall. !!! 😂🤦🏻‍♂️🤦🏻‍♂️🤦🏻‍♂️ - this led me in a better direction, but it does not help me one bit

So much for the customer is always right😂😂😂😂

The old cliche saying is work smarter not harder

I only watched the video after I got it done. Cuz I got disgusted watching idiots attempting to tell you how to remove it and do the alternator swap

At least you're smart and straightforward in willing to learn something

taken bracket out of the way is being smart , avoid injuries to hands and fingers, I'm 64 and doing alternator swap in my front yard. and it's taken me 47 mins to remove it. most videos and tech talks are bs ,you don't need to jack the engine up or losen motor mount brackets. you smart always say reevaluate the situation

Mine blows out cold air for a bit but then stops right away and blows nothing but hot air,and i noticed it had too much freon,would it be better to take some out somehow?

I just replaced mine in april and im getting this poppin noise does it mean they need to be pushed back into place? Are you guys in orlando?

Would this code also make the yellow wrench pop up?

Thats Dorman for ya! Things are always reversed/mirrored from the original. That’s not how you install the bottom two mounts. 😂

In the beginning you say 2011 smart car. In the end you say 2010 smart car :) it's the same, but it was funny for me to notice :) great video, I watched it multiple times as I am doing the same work, thank you

Thanks. I love you so much

I never got the axle to come free. Just scraped the pos 09 milan

u didn’t move the camera so we could see what u hooked the hose onto smh your video sucked

thanks now i see why they say to drop the engine, and thats the way i will do it

No funciona el clima de mi Pontiac montana 2002 que puedo hacer??? Gracias

You’re my hero, I just put a head in my daughter’s car and it started but after driving it quit. It had the exact same issue that you showed. The one bolt I missed. Thanks!!!

I wish you could have showed us how you pushed that back plastic piece off and actually watched you take everything apart would have been a lot nicer

Funny how the customer says it’s not the gas cap.

The noise😵‍💫